InSoFast Panel Features:

Closed-Cell High Density Polystyrene Foam

The InSoFast panels are made up of fire-retardant foam. This type of foam is rated for below grade applications and does not absorb moisture like the open-cell type of bead board.

InSoFast is a Type III Vapor Retarder and is inherently mold resistant. This type of foam is the perfect insulating material for basements.

Alignment Notches

A unique self-aligning notch system is designed into the InSoFast panels to assure that the panels are installed on the concrete surface in alignment. This keeps the studs and wiring chases aligned.

Tongue & Groove Edges

The tongue-and-groove design on the ends of the InSoFast panels help to keep them flush on the surface. This also keeps moisture from traveling to the front side of the panel.

Wiring Chases

Wiring Chases run vertically at 16" on center and horizontally at 24" on center in the panels. This grid-work of chases provides easy access to pull wiring to any location.

The chases also provide the necessary separation from the drywall face to protect the wiring as required by electrical codes.

Ribbed Gluing Surface

Each InSoFast panel has three attachment studs with a ribbed surface to allow the adhesive to maintain a tight adhesion to the wall.

The studs can be located with a stud sensor.

Recessed Attachment Points

The three recessed attachment points on the face of the integrated stud allow for any mechanical fastening that may be needed.